Nandrolone Decanoate 200mg/Ml sara@chembj.com

Liquid DECA Concentration is below here: 200mg/ml, 250mg/ml and 300mg/ml. Welcome to inquiry!

Quick Detail:

1). Popularity of Deca Durabolin
The unusual properties of Deca Durabolin are due to its parent steroid, nandrolone, also known as 19-nortestosterone. One of the principal positive qualities of nandrolone is that it has relatively low conversion to estrogen compared to testosterone.
In earlier years, testosterone and nandrolone were the only pharmaceutical injectables that were both widely available to bodybuilders and economical. Estrogen control did not then exist. For this reason, Deca's low aromatizing properties were then quite useful. Deca therefore won wide popularity.

2). Deca Durabolin Effects on Hair and Skin
An additional advantage of Deca Durabolin is that this compound is relatively mild in terms of adverse side effects on the scalp and skin. This is because the 5-alpha reductase enzyme acts to reduce the potency of nandrolone, while in contrast many other anabolic steroids are unaffected by this enzyme, and testosterone's potency is actually increased by it.

3). Homebrew Recipes
A. Requirements:
10 grams Deca-Durabolin - nandrolone decanoate - - powder
37.5 ml sesame oil
Benzyl Alcohol 2.5 ml 5% BA
Benzyl Benzoate 2.5 ml 5% BB
Syringes 3cc & 5/10cc
18 or 20 gauge needles
Vial
Sterile Vial
Whatman sterile filter

B. Procedure:
(1). Measure 10 grams of powder
(2). Place the powder in the vial
(3). Add BA to the vial
(4). Add BB to the vial
Heat the oil in a suitable container in the oven to a minimum of 212 degrees F to sterilise it (it will likely be necessary to use slightly more oil than listed as you will not be able to utilise all of it)
(5). Add the oil to the vial but save 2 ml of oil in the syringe for later
(6). Gently shake the vial.
(7). Reheat the mixture if necessary by placing the vial in a frying pan and place it on the eye of the stove
(8). Place an 18 or 20 gauge needle in the sterile vial and attach the Whatman sterile filter
(9). Place another needle in the sterile vial to relieve the pressure
(10). Draw out the solution with a syringe and run it though the Whatman filter
(11). Take the other syringe with 2 ml of oil (saved previously) and run it through the Whatman (12). Filter into the solution.

First of all how would you change the deca to 250mg
And how do you add bb to the test one and how would you change them both to
Ba 2% bb 15%
Been reading and these seem like the best ratios.

If you are interested in this item,E-mail me or skype me,let's talk more details.
E-mail:sara@chembj.com
Skype:sara92362
Web:http://www.steroidhome.com

Permanent link: http://www.vvchem.com/sell/cas:360-70-3,3293626.html